Monday, April 15, 2013
THE USE OF THE PROCEDURE/TOYOTA DAYTIME HEADLIGHT REPAIR GUIDE
Wire harness repair central locking tool to pick the series and back out to the Terminal to the appropriate connector DRL relay or body to the ECU. See page 1 of this bulletin reference chart for the pin and the connector. 3. isolate the removed terminal using a vinyl electrical tape. 4. attach the wire and outside the Terminal, use vinyl electrical tape the wiring harness. Note: the 2000 MY Avalon, go to step 5. All remaining models go to step 6. 5. the financial year 2000 model Avalon: a subscription to the new terminal will result in every size and type of the Terminal previously removed from the connector. (PN 82998-12690) (B) securely attach to 45 cm/18 wire diameter 2.0 mm or larger new Terminal tail. Repair procedure for the DRL relay, or ECU W/H body to isolate the Terminal tape insulated from outside the Terminal wiring harness. 82998-12690 P.N.
Daytime HEADLIGHT removal procedure-EL011-00-6. October 2000, page 3/3 (C). securely connect the eyelet hole size of 7 mm from the end of the new wire. D. Insert new terminal will result in the body ECU B5 previously removed from the original connector terminal. E. right to assign and route a new thread in the current leadership of the series in a way that prevents it can become damaged or contact with other circuits on the outside. (F) to the left of the opening kick Panel. safely attached to the central authorities of the territory of the present. (Ground point if) 6. check that the daytime headlight (DRL) function is disabled. 7. the size of the Interior panels, which were removed to gain access to the components, connectors, etc.
No comments:
Post a Comment