Wednesday, April 17, 2013
2001 Hyundai Accent GS sedan speed sensor service transfer procedure
Pulse generator-(B) the inspection procedure: 1. open the hood. 2. remove the resonator. 3. find the pulse generator under the battery tray. Remove the pulse generator connector (blue) and remove the pulse generator male connector (black) from the bracket. 4. using an ohmmeter to check the resistance of the Terminal No. 3 and no. 4 of pulse generator in the male connector (black color). The resistance value: 215-275W (at 20 ° C or 68 ° F) If the resistance is less than or greater than the specification, replace the pulse generator (P/N 22700 45955). If the resistance is the specification for the go to step 5. 5. clean the connectors on both ends of the touch of the pulse generator, aerosol cleaner. 6. Fat contacts (P/N 00305 NYOGEL 760 g-F0000-39,), all four of the slots on the Terminal in a blue female connector until the opening of each terminal is completely filled with grease. 7. connect the pulse generator terminals and fasten the connector bracket. When all the parts of the removal of the off in reverse order. TCM SPECIFICATIONS WARNINGS BEFORE again at 1. Repeat the ignition key to the "ON" position. 2. be careful not to disconnect all cables on the vehicle structure or on the Hi-Scan Pro during the review. 3. do not start the engine or turn off the power key during restart. Warning: If the reprogramming is interrupted, the manual update procedure must be used. 4. when retargeting is ready, turn off the ignition key for 20 seconds before engine start. TCM REPROGRAMMING procedure: 1. Insert the 16 MB card at the beginning of the reprogramming of the Hi-Scan Pro card slot. 2. connect the adapter on the renewal of the plans for the Hi-Scan Pro. 3. connect the white connector of the adapter on the reprogramming of the renewal plan (2-pin or 10-pin). Note: use the correct connector: ^ 2000-01 accent: the white 2 pin connector. ^ 2002 Accent: white 10-pin connector 4. Connect the power to the Hi-Scan Pro cigarette power adapter. 5. connect the power cord to the power supply adapter into the cigarette on the renewal of the plans.
Thanks for the post. Great Work!!
ReplyDeleteSpeed Sensor