Tuesday, April 16, 2013
2000 Cadillac Catera timing belt service and repair manual
Timing belt replacement timing belt REPLACEMENT removal procedure tools required J ^ 42069 timing belt alignment Kit-J 42098 crank Hub Torx Socket notice: failure to follow the described timing belt inspection and maintenance can lead to a broken timing belt and result in serious engine damage. 1. check cold start counter (also called heavy duty register) scan-tool. Is there any cold starts (less than 28 ° C or-20 ° F) visually inspect the cracks on the timing belt. It cracks, again with the belt. Replace the belt and remove the cold start counter. If the belt is in good shape and is used again, do not remove the cold start counter. 2. remove the Air intake resonator. For more information on the intake of the air conditioning in the resonator replacement Powertrain management. 3. Remove the intake session. For more information about the intake session. 4. remove the timing belt. For more information about the replacement of the timing belt cover. 5. remove the crankshaft balancer bolts. 6. remove the crankshaft balancer of the crankshaft sprocket. 7. Rotate clockwise 60 degrees before Top Dead Center (BTDC) 8. Install the crankshaft sprocket (J) 42069-10 lock nut on the bolt of the crankshaft. 9. Carefully turn the crank shaft of engine rotation (clockwise) until the lever (J) 42069-10 touch the water pump pulley flange (J) 42098 firmly. 10. secure the tool to the water pump pulley flange movable lever. Important: make sure that the crankshaft is not 180 degrees away from the TDC. Cam shaft gears should be harmonised in the corresponding section of the reference marks on the rear timing belt cover at this stage. If they are not uniform, the engine is 180 degrees off. 11. install the J-1 and J 42069 42069-2 cam gears. If the J-1 or J-42069 42069 2 fit the camshaft gear teeth, it may be necessary to remove the timing belt idler pulley and turn the cam until the J-1 or J-42069 42069-2 can be added. Warning: Once the timing belt has been removed, do not turn off the cam and crankshaft independently. If enabled, the interference may occur in the Pistons and valves and pistons and valves may be damaged. 12. loosen the timing belt tensioner and idler pulleys. Important: Remove 42069 42069 1 J and J-2, when the strap has been removed. 13. Remove the timing belt. Installation and adjustment of the procedure ^-J 42069 timing belt alignment Kit-J 42098 crank Hub Torx Socket tools required
No comments:
Post a Comment