Wednesday, April 17, 2013
1982-2002 Chevy Camaro and Firebird EDELBROCK adjustable PANHARD ROD installation instructions
1. raise the vehicle and support on jackstands. Note: the vehicle must be supported by the vehicle's normal weight on the rear axle. 2. remove the bolts to the stock panhard rod ends-and remove the stock panhard-bar. Check the hardware, and replace if necessary. 3. clean the hardware and panhard Rod mounting brackets. 4. install Edelbrock panhard rod on stock hardware. Use one drop of blue locktite to clean the bolt threads and torque to 50 ft. lbs. Note: the new adjustable panhard rod is mounted on the driver's side of the vehicle-the adjuster sleeve. 5. the Edelbrock panhard Rod are greased during Assembly, but it is a good fat penetrators, after installation and during normal operation. 6. the new adjustable panhard rod is adjusted to the length of the vehicle. To adjust, simply loosen the two jam nuts and turn the adjuster sleeve until the rear-end will be centered. Check out the side of the tyre, measured the fender lip. Both parties should be the same.
No comments:
Post a Comment