Wednesday, April 17, 2013
2007-2009 Chevy GM kuorma 6-LUG malleja asennusohjeet
1. place the vehicle on a flat surface and use a floor Jack and Jack stands to raise the front of the vehicle frame so the wheels are off the ground. 2. remove the front wheel on the driver's side of the vehicle. 3. remove the sway bar end link. 4. open the three upper strut mounting nuts, but do not remove them. 5. search the ABS line and disconnect the Upper control arm. 6. remove the two lower strut mounting bolts. 7. remove the upper ball joint nuts and shaft, but don't delete them. Note: with a hammer may be needed to break the ball joint for free. 8. now remove the ball Joint nut, three upper mounting nuts, and remove the strut from the vehicle. 9. is removed from the vehicle suspension seat leveling spacer on top of the strut Assembly, then again in the stock location on the strut Assembly the new nuts Kit. 10. install the upper ball joint nut and sway bar end link. Note: it may be necessary to use a pry bar to support the installation of the strut Assembly. It is also necessary to raise A forearm to get the ball Joint nut installed a Jack. 11. check that all fasteners tight at factory specs. 12. install the wheel and torque to OEM specifications. 13. the objectives of the second vehicle. 14. adjust the headlights and get in line certified alignment technician who is experienced in the increase of vehicles in the vehicle. PROFESSIONAL INSTALLATION IS RECOMMENDED BY A CERTIFIED INSTALLER OF
No comments:
Post a Comment