Monday, April 15, 2013
1984 Toyota Pickup ignition system-electric Toyota Nippondenso electronic ignition Repiar manual
High-voltage wire resistance 1. Set ohmmeter x 1000 range, and connect the leads to the high-voltage wire at each end. Isuzu P'UP I'Mark and the resistance should not be 73,500 ohms per foot. 2. Select the other models are opposed to a maximum of 25,000 ohms per thread. In this case, the switch wires. Figure 5: checking the pick-up Coil Resistance connect ohmmeter leads to distributor connector terminals. Pick up Coil Resistance set the ohmmeter x 100, a measure of the resistance of the coil distributor pickup connector. See Figure 5 and a pick-up coil (signal generator) are AGAINST the table. Also the wires for shorts or opens. The pick-up COIL (signal generator) resistance (ohm) Note: on Toyota Celica, 4Runner and Pickup models, Starlet, the signal generator is used in the pick-up coil.
No comments:
Post a Comment