Wednesday, April 17, 2013
2001 Chevy truck-S10/T10 Blazer intake manifold (upper)-removal and installation manual
Intake manifold intake manifold (upper) notes that the Exchange-upper removal procedure important: the upper intake there is no need to remove the lower intake manifold. 1. disconnect the breather pipe is cleaner in the outlet air ducts (2). Uninstall cleaner outlet air ducts keep the wingnut. 3. disconnect the IAT sensor harness connector 4. Removing the throttle body air duct cleaner into the outlet. 5. disconnect the accelerator cable throttle body 6. Remove the accelerator control cable Accelerator cable bracket. 7. disconnect the cruise control cable, if the throttle shaft and the accelerator cable bracket. 8. disconnect the vacuum hose vacuum tank to the intake manifold. 9. disconnect the power brake booster vacuum hose. 10. disconnect the electrical connectors: * the a/c compressor clutch (1) * a/c compressor cut-off switch (5), if the * Throttle position (TP) sensor (2) * Idle Air Control (IAC) motor (3) 11. Disconnect the electrical connectors: * fuel meter to the frame (1) in the intake manifold absolute pressure (map) sensor (3) * the EVAP canister solenoid valve, remove the (2) 12. Remove the accelerator cable bracket to the engine wire harness clip. 13. move the engine wiring harness aside. 14. remove the accelerator cable bracket to the throttle body and intake manifold. 15. remove the accelerator and cruise control cable bracket to the throttle body. Leave the accelerator and cruise control cables bracket16. Remove the PCV valve hose to the intake manifold and valve cover on the swing, the combination of the lever. 17. remove the bracket for the engine wiring harness intake manifold stud. 18. remove the fuel lines from the fuel meter body. 19. remove the EVAP canister, remove the solenoid valve.
No comments:
Post a Comment