Monday, April 15, 2013
2004 Toyota Sienna POWER SLIDING DOOR NOT WORKING repair manual
Remove the slide door on the window decoration. (A) to fully open the door to the slide window. .. B. remove the glass on the drive. (C) using the screwdriver. loosen and remove the clip for garnish. Tip: Tape the screwdriver tip before using. D. taped a screwdriver to disconnect the 2 nails and remove the inner weatherstrip for garnish. Parts of the information OUT of the POWER SLIDING DOOR repair procedure clip-EL004-04 April 19, 2004, page 3/7, 2. Remove the side cover on the back of the Board to cut. A. remove the 2 screws. (B) use a screwdriver to disconnect the taped 8. nails and remove the cover together with the window control switch. (C) remove the 2 screws and the window control switch. 3. remove the rear door trim Board Sub-Assembly. A. remove the screw. (B) use a screwdriver to detach the 9. taped clips and remove the trim. Tip: in order to ensure that the door panel from damage, covers areas where the protective tape of the arrows in the figure. 4. remove the rail end of the molding. A. open the quarter glass. (B) to detach the clip and taped screw., 2 nails and remove the rail ends with molding. Repair procedure (continued): the claw 1 2 3 4 5 5 4 3 2 1 the protective tape protective tape: Clip: the Clip: the claw POWER SLIDING DOOR BROKEN-EL004-04 19 April 2004 page 4/7, 5. Remove the Center bracket to no. 2. A. remove the 2 bolts and the Center mounting bracket No. 2 as well as the tensioner (color: white). (B) remove the tensioner the Center bracket to no. 2. 6. remove the Center bracket No. 1. A. remove the 2 bolts and the Center mounting bracket No. 1 as well as the tensioner (color: black). (B) remove the tensioner the Center bracket No. 1. 7. to remove the slide from the door window, LH. A. remove the parasol: the Sun in the shade of the hook. (B) remove the bolt and the framework. C. remove the bolt. D. loosen the nut. E. press the lower window on the rear frame image in the direction of the arrow
No comments:
Post a Comment